configure bootprelay

configure bootprelay [ {vlan [vlan_name]} [add ip_address | delete [ip_address] | all ]]

Description

This command configures DHCPv4 server/next hop relay for each VLAN IPv4 interfaces. This command is not applicable to IPv6 interfaces. Configuring bootprelay per VLAN v4 level is supported only on IPv4, and not on IPv6.

Syntax Description


bootprelay	BOOTP Relay service.
add	Adds DHCP BOOTP Relay server.
delete	Deletes DHCP BOOTP Relay server.
`ip_address`	IP address of bootp relay server.

Default

N/A.

Usage Guidelines

Use this command to configure the DHCPv4 server/next hop for each VLAN interface. The configuration applied to the VR level is populated to all VLAN v4 IPv4/v6 interfaces.

Example

The following example displays IPv6 bootprelay information:

# sh bootprelay configuration ipv4
DHCPv4 BOOTP Relay : Enabled on virtual router "VR-Default"
    Include Secondary    : Disabled
    BOOTP Relay Servers  : 10.127.6.243
    DHCP Relay Agent Information Option: Disabled
    DHCP Relay Agent Information Check : Disabled
    DHCP Relay Agent Information Policy: Replace


VLAN                                    DHCPv4 BOOTP Relay
------------------------                ------------------
VLAN "Default":
    BOOTP Relay                        : Enabled
VLAN "client":
    BOOTP Relay                        : Enabled
    BOOTP Relay Servers                : 10.1.1.1   10.127.6.101   10.127.6.243
    DHCP Relay Agent Information Option: Disabled
    DHCP Relay Agent Information Check : Disabled
    DHCP Relay Agent Information Policy: Replace
VLAN "client1":
    BOOTP Relay                        : Enabled
VLAN "dhcpv4server":
    BOOTP Relay                        : Enabled
VLAN "server":
    BOOTP Relay                        : Enabled

History

This command was first available in ExtremeXOS 15.5.

Platform Availability

This command is available on all Universal switches supported in this document.